Component Solution Services REC02F Wartungshandbuch Seite 54
- Seite / 142
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Ultraview 1030/1050 Monitors — Service Manual
3-14
Battery Chargers
The battery chargers have the following features:
• Front panel LED battery charging/failure indicator.
• Automatic “battery care” recharge cycles to ensure a maximum charge.
• One or two batteries fully charge in 90 minutes if the system is not operating; 4 to 5 hours
while unit is operating.
• Individual battery chargers for each of the 2 batteries so that a bad battery will not degrade the
other battery. Will not prematurely “kill” batteries.
Figure 3-7: Charging circuit block diagram
12-to-24 V
DC input
charger pre-regulator
charger power converter
charger CPU IC
DC output
20 V
DC to DC converter
3.6 A max current at
20 VDC. MIC38HC43
IC chip, 100 KHz
Compute battery condition
Turn ON/OFF power converter IC
CPU controlled battery
battery charge rate
1.8 A max, 0.16 A min
Analog feedback
Using DC charge levels and
an AC waveforms, evaluate
battery internal condition
+
charger output to battery
+
5
v
+5 V
BTI CCS9620 IC chip
Convert 20 V to 10 V min and
15.1 V max; constant current
limited with constant voltage
limited; LT1511 IC chip
12 V lead
acid battery
battery fault
automatic fan control
- Ultraview 1
- 1030 and 1
- Ultraview 1050 Monitors 1
- Table of Contents 3
- Introduction 5
- Monitor Hardware Options 6
- Unpacking 9
- Batteries 10
- Nickel Metal Hydride (NiMH) 11
- Battery Use 11
- Sealed Lead Acid (SLA) 11
- Caution: 12
- Assembly 13
- Back Panel Connections 14
- Power-ON Test 16
- Cables and Adapters 18
- Maximum Cable Lengths 18
- Software Configuration 19
- CONFIGURABLE 22
- ALARM TONES 22
- CONTINUOUS 22
- Keyboard Menu 23
- Biomed Setup Keys 24
- TCP/IP Setup Key 25
- BED NAME Key 25
- NODE DIRECTORY Key 25
- RECORDER SETUP Key 26
- RECORDER NAMES Key 27
- SELECT RECORDERS Key 27
- Select option to change 28
- Select recording type 28
- Select beds/subnets 28
- ALARM SETUP Key 29
- HIGH MEDIUM 30
- USER ACCESS Key 31
- TONE CONFIGURATION Menu Tree 31
- SERVICE FUNCTIONS Menu 32
- STATISTICS 33
- SITE SURVEY Key 34
- PRINT Key 34
- CHANGE PASSWORD Key 34
- RESET MONITOR Key 34
- Updating Flash PROM 35
- Network Configuration 35
- Ethernet Installation 36
- Ethernet Removal 36
- Module Tests 36
- 90310 Front Panel 37
- DC Power Supply 42
- Parameter Module 42
- Optional Capnography 42
- 90367/90369 Monitor 43
- CPU PCBA 44
- Main CPU 45
- MPC860-PCI Bridge 45
- Ethernet 46
- PMC Connector 46
- ISA Bridge 46
- Wireless LAN Card 47
- Keyboard/Mouse Interface 47
- ISA I/O Buffers 47
- SDLC Interface 48
- Touchscreen Circuitry 48
- Nurse Alarm Output 48
- Clock Distribution 48
- Hardware Reset 49
- Software Reset 50
- Power Failure Operation 50
- Hard Reset Configuration Word 50
- Interrupts 50
- Power Supply System 52
- Battery Chargers 54
- Normal Operation Overview 56
- EMI Reduction 56
- Boot Sequence Overview 56
- Touchscreen PCBA 58
- 26 gnd Input 59
- I/O Bay PCBA 60
- Recorder Interface PCBA 62
- ICB (Interconnect PCBA) 63
- Maintenance 65
- Fan Filter 66
- Mechanical Inspection 67
- Electrical Safety Testing 67
- Definitions 68
- Ground Resistance 69
- Chassis Leakage Current Tests 69
- Preventive Maintenance 70
- Functional Checks 70
- Capnography 72
- Part Replacement Procedures 74
- Replacing the Main PCBA 75
- Removing the Chassis Assembly 76
- Removing the Door 80
- Removing the Bezel 82
- Removing the I/O Bay PCBA 84
- Removing the CO 86
- PCBAs for Option G 86
- PCBAs for Option H 88
- System Startup 90
- Boot Menu 91
- Power ON Diagnostics 93
- Extended Diagnostics 93
- Diagnostic Menus 94
- MEMORY MENU 96
- Diagnostic LED 98
- Error Log 99
- Troubleshooting 101
- System Troubleshooting 103
- Touchscreen Troubleshooting 104
- Ethernet Troubleshooting 105
- Module Slot Troubleshooting 105
- SDLC Output Troubleshooting 105
- Battery Troubleshooting 107
- Recorder Troubleshooting 108
- Capnography Troubleshooting 113
- Does Not Display 114
- Reads Low 115
- Check Reads Low 115
- Problem Messages 116
- Contents 119
- Overview 119
- Field Replaceable Parts List 119
- Drawings 123
- Appendix A — Glossary 125
- Appendix B — Electromagnetic 131
- Compatibility 131
- Electromagnetic Immunity 132
- Interference 134
- Mitigation 134
- Appendix C — Symbols 135
- 12,200 m 137
- Approved 140
- ETL Laboratory Approved 140
Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Component Solution Services REC02F
(41 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.071 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern